FS: Garrett GT2560R, Magnaflow high flow cat
#1
Senior Member
Thread Starter
iTrader: (8)
Join Date: Jun 2010
Location: Florida
Posts: 1,116
Total Cats: 43
FS: Garrett GT2560R, Magnaflow high flow cat
I'll be headed out of town this weekend....hit me up quickly and I can get the parts out before I leave
I only put about 1000 miles on this thing, guy before me said it had 3k or something on it. Made 275whp with it @ 16 psi...but putting on a GT2871R now. Zero issues, worked great. Zero to minimal shaft play. I have my brand new, never used GT2871 next to it and they feel identical. I had boost creep issues on my old setup you might have seen, but was almost 100 percent certainly from the downpipe design.
Has brand new adjustable 6-12psi actuator from Begi (ok, has about 400 miles on it). Also the wastegate has been ported, along with a channel leading up to the WG. Also a 'divider plate' has been welded into the turbine outlet section, apparently what begi is doing to all their turbos going out now?
Includes ATP billet aluminum inlet/outlet flanges ($80 new I think?) 3" inlet, 2" outlet.
I can throw in some of the oil/water inlet/outlet/fittings if you need them...lemme know and we can discuss.
$600 shipped
-----------------------------------------
Magnaflow metallic-spun high flow cat (part#59959)
SOLD
------------------------------------------
I only put about 1000 miles on this thing, guy before me said it had 3k or something on it. Made 275whp with it @ 16 psi...but putting on a GT2871R now. Zero issues, worked great. Zero to minimal shaft play. I have my brand new, never used GT2871 next to it and they feel identical. I had boost creep issues on my old setup you might have seen, but was almost 100 percent certainly from the downpipe design.
Has brand new adjustable 6-12psi actuator from Begi (ok, has about 400 miles on it). Also the wastegate has been ported, along with a channel leading up to the WG. Also a 'divider plate' has been welded into the turbine outlet section, apparently what begi is doing to all their turbos going out now?
Includes ATP billet aluminum inlet/outlet flanges ($80 new I think?) 3" inlet, 2" outlet.
I can throw in some of the oil/water inlet/outlet/fittings if you need them...lemme know and we can discuss.
$600 shipped
-----------------------------------------
Magnaflow metallic-spun high flow cat (part#59959)
SOLD
------------------------------------------
Last edited by aaronc7; 09-15-2011 at 10:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post