Garage cleanout
#1
Junior Member
Thread Starter
Join Date: Aug 2014
Location: North Carolina
Posts: 409
Total Cats: 114
Garage cleanout
Typical garage cleanout thread. A lot of these parts are back from when I had intended to chase the big boosty life. All parts cheaper than I paid.
Prices do not include shipping.
Prices do not include shipping.
- RevLimiter window switches - $100 - Bought used. Whatever Rev cast the bracket out of was junk and warped, I cut up a manual window block off plate to have it sit flush. Ran for a while, a switch stopped working. I replaced it with a new one, cleaned the old switch, and verified the fix was good it worked before putting in the new switch. Second switch went bad and I reverted to stock switches. A new switch ($10) will fix it and is commonly available at any electrician supply warehouse.. All spare parts included, including the cleaned original switch.
- Billie coilover setup - $180 - Allstar Performance Coilover sleeves and QA1 450/300 High Travel 7" springs. These were used on NB Miata Bilsteins on my NA Miata prior to an accident that totalled the car. I would guess they had 20,000 miles on them, all of which were accumulated in 2015 (I drove the car 14k miles across the country) with them installed. They've never seen salt or anything. There is minor corrosion on the springs from dirt and rubbing the coilover sleeves. Two sleeves were cut down shorter to prevent rubbing in the rear, as per recommendations in the Budget Billies thread. Otherwise they look to be in good condition.
- Wilwood prop valve - $40 - Used but not by me. Picked it up from a local partout after a guy blew up his second or third turbo engine. I never decided to install it as it seems for my big Sport brakes it would just wind up at full rear bias and not really change anything.
- SOLD DW200 pump - $75 - Never used, purchased 2018.
- SOLD FM Level 1 clutch - $325 - Never used, purchased 2018. Rated to 318 lb-ft of torque. All parts included - Clutch, throwout bearing, clutch pedal switch override. Pressure plate and friction disc are still in the plastic.
- SOLD FM EGR blockoff - $10 - Never used only removed from plastic.
- SOLD NB1 / '99-'00 / BP4W fuel rail - $50 - Purchased from Treasure Coast Miata to fit an NB1 VICS intake manifold I've already sold. Thoroughly cleaned by me after I got it and has been sitting inside my house since. I'd recommend giving it a quick flush before you put it on your engine just as a matter of course.
-
DW200
DW200
FM clutch setup
pressure plate
EGR blockoff
Window switch, fuel rail, prop valve
Window switch close up -
Last edited by OptionXIII; 09-09-2021 at 02:39 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Chowcow
General Miata Chat
18
03-27-2015 08:31 PM
MikeRiv87
General Miata Chat
49
09-10-2011 07:54 PM