MS2 DIY PNP 99-00
Thread Starter
Junior Member
iTrader: (4)
Joined: Jun 2013
Posts: 148
Total Cats: -3
From: Dallas TX
This MS was purchased from an active member on this site. It was pulled out of my car 2 weeks ago. It was running my 99 for over a year. Everything worked great except the "voltage meter" and AFR in TunerStudio. it would sometimes show the wrong voltage and AFR was stock at 12.1 . My fix was to not run any injector voltage correction, and do all the tuning based on the wideband display(on the dash). The car ran strong, never had a any misfire problems or no start. I never had the time or knowledge to fix these issues. I did see on a page that people have seen these issues with bad grounds. I also never got to set the IAC (idle) so I ran the car at 1200 rpms with no IAC, but i think that works just fine just need tuning. Comes with everything in the pictures including the serial to USB wire. $450 or best offer




I was the one who built it, didn't get those issues but seems like a ground from your car.
Just sold it when I got the MS3... wonderful unit and I'm an electrician who specialize in electronics so it's built right.
BUMP
Just sold it when I got the MS3... wonderful unit and I'm an electrician who specialize in electronics so it's built right.
BUMP
Thread
Thread Starter
Forum
Replies
Last Post
compuw22c
MEGAsquirt
18
Oct 13, 2015 04:22 PM
z31maniac
Insert BS here
13
Oct 8, 2015 10:41 PM





