*******************SOLD SOLD SOLD**********************

Sparco Sprint V's in very good condition. Comes with Pro-Car Innovations fixed bracket for the driver's side (very low) and modified NB sliders (with seat belt buckle mount but no buckle). Basically you get everything you need to bolt these right in.

Passenger side cushion isn't even really broken in yet. No visible bolster wear on either seat. The drivers side has a spot where the fabric has pulled away from one of the belt holes. Happened on day one and has not pulled away any more. Can't really notice it unless you poke it like the photo. Also included are the Sparco lumbar cushions and some larger memory foam ones from amazon (more comfortable for long trips).

I also have the seat belt buckle mount for the PCI bracket (you have to drill a hole in the floor). The rear crossbar on the PCI bracket was removed as necessary so you don't sit on the bracket. You're basically sitting on the floor with this setup because the cushion on the Sprint V drops down between the rails.

FIA rating still good for 2.5 years. Not shipping these things, pickup in Hatboro, PA only. Paid over $950 2 years ago. Zero love stains

Driver side - $225
Passenger Side - $300
PCI Bracket - $80
NB Sliders $25

$600 for everything

Prefer to sell everything together so I might hold out for that at first.

 

I would take the drivers mounting bracket if you part them out

 

Interested in the drivers side seat only if you split, can make the drive to you sometime between next wed and the following monday.

 

I'll let you guys know if that is a possibility. I want to wait a week or so to see if there's interest in the whole set. Trying to avoid a bunch of transactions since I don't have a lot of free time with a 4 month old baby

 

If you change your mind on shipping I'm interested Can the driver's side accept stock rails if I 'massage' them too? Currently have a momo start for a driver's seat, but my passengers thrash about without the support of the bucket and I can't find another matching start seat.

 

Drivers side will work with stock sliders if you make quick brackets out of angle. I've seen it done in 1/8" aluminum angle. The width spacing is different from passenger to driver side. Passenger spacing is the same as the Sparcos

Regardless though, the seats have been sold locally on CL. Still have the PCI bracket and will be sending a PM followup to btabor. I also still have a set of NA sliders (I'm keeping the NB one's in case I want to put the stock seat back in).

 

If anyone wants to calculate for shipping on the PCI bracket just go to USPS.com and calculate for a 10lb package from 19040

 

Everything sold, mods please close if necessary