WTS: MP62, TDR FMIC, TB redesign, ECT
#1
Elite Member
Thread Starter
iTrader: (7)
Join Date: May 2007
Location: Dallas, Tx
Posts: 3,006
Total Cats: 103
WTS: MP62, TDR FMIC, TB redesign, ECT
Thinking about selling my mp62, tdr fmic, tdr pulley tensioner, 65mm and 62mm pulleies, radiator cover, header, greedy type-s (or rs not sure) bov ect.
Kit is a direct NB bolt on but will work on a NA with some modification. Has sub 15k miles on it.
I run this set up in a single throttle body config with a bov. This removed all throttle lag and throttle dip/engine cut when slowing down or running ac issues you get with a mp62 off the shelf with it relocated throttle body to the back of the blower configuration. This also netted 10whp more.
On a stock 99 block I am seeing 225whp/190wftlb on a mustang dyno so add 6 to 8% for real world/dyno jet power.
You will need bigger injectors, bigger fuel pump and a ecu that runs map. Set up will not work with maf.
Going to start high at $3500 obo
If it sells 99 compete motor will be up for sale next.
requested dyno (afr reader on dyno is wrong) Belt slipped at 6000+ rpm
Kit is a direct NB bolt on but will work on a NA with some modification. Has sub 15k miles on it.
I run this set up in a single throttle body config with a bov. This removed all throttle lag and throttle dip/engine cut when slowing down or running ac issues you get with a mp62 off the shelf with it relocated throttle body to the back of the blower configuration. This also netted 10whp more.
On a stock 99 block I am seeing 225whp/190wftlb on a mustang dyno so add 6 to 8% for real world/dyno jet power.
You will need bigger injectors, bigger fuel pump and a ecu that runs map. Set up will not work with maf.
Going to start high at $3500 obo
If it sells 99 compete motor will be up for sale next.
requested dyno (afr reader on dyno is wrong) Belt slipped at 6000+ rpm
Last edited by jeff_man; 07-17-2013 at 05:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post