FS: turbo manifold, wheel adapters, clutch, hazard switch
05-15-2008, 11:03 PM
#1
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
FS: turbo manifold, wheel adapters, clutch, hazard switch
$150- JGS DIY manifold- has a T3 flange
$160- 4x100 to 4x108 spacers, 1" thick. brand new, I removed one to take a picture, the other two are still in the box.
$60- flyin miata replacement clutch with a brand new TOB. Clutch is used, but still has plenty of life left.
$10- pop up light/hazard switches and the 2 bobble vents, they work fine
$160- 4x100 to 4x108 spacers, 1" thick. brand new, I removed one to take a picture, the other two are still in the box.
$60- flyin miata replacement clutch with a brand new TOB. Clutch is used, but still has plenty of life left.
$10- pop up light/hazard switches and the 2 bobble vents, they work fine
Reply
0
0
06-20-2008, 06:12 AM
#9
Senior Member
Join Date: Mar 2006
Location: Ireland
Posts: 534
Total Cats: 0
I just tried fitting one of them and found that the bolts do not line up with a set of 17" Mazda alloys. The holes DO line up with the hub, but not the bolts, their off by about 1/4" :(
Are you sure these spacers are for a miata ?
Are you sure these spacers are for a miata ?
Reply
0
0
06-20-2008, 09:23 AM
#10
Senior Member
Thread Starter
iTrader: (9)
Join Date: Jun 2007
Location: NH
Posts: 1,013
Total Cats: 21
What year is your car? I bolted 2 of them on my 1990 with a set of 16x10 Epsilons. I never drove the car as they were too wide with the adapters to fit...plus my car is still a project
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Andifer
Miata parts for sale/trade
8
09-23-2015 05:43 PM
