Basic MS3 - Now available from MS Labs!
#142
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 857
How to control VICS, I see nothing in TunerStudio
Here's a comparison sheet (Basic MS2 - Enhanced MS2 - Basic MS3 - MS3/MS3X - Enhanced MS3)
MS Labs ECU Comparison Sheet
MS Labs ECU Comparison Sheet
Any help on this?
#143
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 857
How to set up Limp Mode(s) using TS?
How does one set up or test limp modes on MS3 using TunerStudio?
I see the CAN-bus/Testmodes, but don't see how to access most of the functions.
Note: I am OFFLINE. If I just need to be synced, then I'll figure this one out.
I see the CAN-bus/Testmodes, but don't see how to access most of the functions.
Note: I am OFFLINE. If I just need to be synced, then I'll figure this one out.
#148
Rev can you PM me w/ other contact info. Looking for a quote. (don't have enough posts here yet)
Thanks
Thanks
#150
#151
Hi Reverant,
In the SCCA Solo STS class we are allowed to adapt in a stand-alone controler but we are not able to add any sensors. We must use the AFM and throttle switch and can't add a MAP sensor.
Can your MS3 or some version of it work with this? Several others are working the same idea. There's a thread on the question here.
For me personally I need an STS compliant solution but would also like to some day put in an NB2 VVT engine or KLDE V6 (fully sequential). I'm wondering whether this can all be supported with a customized MS3 based solution.
Thanks.
Jay
In the SCCA Solo STS class we are allowed to adapt in a stand-alone controler but we are not able to add any sensors. We must use the AFM and throttle switch and can't add a MAP sensor.
Can your MS3 or some version of it work with this? Several others are working the same idea. There's a thread on the question here.
For me personally I need an STS compliant solution but would also like to some day put in an NB2 VVT engine or KLDE V6 (fully sequential). I'm wondering whether this can all be supported with a customized MS3 based solution.
Thanks.
Jay
#153
Thanks
#156
Here's a comparison sheet (Basic MS2 - Enhanced MS2 - Basic MS3 - MS3/MS3X - Enhanced MS3)
MS Labs ECU Comparison Sheet
MS Labs ECU Comparison Sheet