AEM CAN with MS3 and other CAN devices?
#1
AEM CAN with MS3 and other CAN devices?
i知 setting up the gauges and ms3 on my 1990 1.6l turbo build right now. i plan to use a canchecked can gauge, this aem 30-0300 uego wideband and an aem 30-0306 boost gauge on an ms3pnp pro. currently i知 wiring up the wideband and i致e read that it was possible to hook up the aem 30-0300 (or any other aem can peripheral) via canbus using options port G (canL) and I (canH) to the megasquirt extras port, but you will loose the ability to connect any other CAN devices to that network. but then i just found this recent post, where it seemed possible:
https://www.miataturbo.net/general-miata-chat-9/can-bus-wiring-question-ms3pnp-canchecked-aem-x-series-108216/
is it possible to run these 2 aem gauges and a canchecked MFA? i知 also using 2 aem temp and 1 aem pressure sensors. or how can i do multiple can connections? all 3 gauges ill be using have can options and i知 unsure how to wire it up. apologies if it痴 been further clarified or explained elsewhere, i知 still a little new and a little retarded with wiring, and trying to get the car started on a time crunch
https://www.miataturbo.net/general-miata-chat-9/can-bus-wiring-question-ms3pnp-canchecked-aem-x-series-108216/
is it possible to run these 2 aem gauges and a canchecked MFA? i知 also using 2 aem temp and 1 aem pressure sensors. or how can i do multiple can connections? all 3 gauges ill be using have can options and i知 unsure how to wire it up. apologies if it痴 been further clarified or explained elsewhere, i知 still a little new and a little retarded with wiring, and trying to get the car started on a time crunch
Thread
Thread Starter
Forum
Replies
Last Post
SpongeBob
General Miata Chat
9
10-25-2023 10:58 PM