hunting idle on hot starts
#1
hunting idle on hot starts
I have a problem recently where on warm/ hot restarts, the car will hunt for its idle.
Climbs to 1800-2000, fuel cuts, drops down to 600ish, (?) Closed loop idle catches it and revs back up. When it drops down, "cranking" illuminates green even though its not. Starting the car from cold, it runs perfectly.
Attached is my tune and two logs, one shortly after starting and relatively cold. and fully warmed up after driving home.
Thanks for the help!
Climbs to 1800-2000, fuel cuts, drops down to 600ish, (?) Closed loop idle catches it and revs back up. When it drops down, "cranking" illuminates green even though its not. Starting the car from cold, it runs perfectly.
Attached is my tune and two logs, one shortly after starting and relatively cold. and fully warmed up after driving home.
Thanks for the help!
#7
This can't be right, there must be something wrong with your cranking settings. Try using 0° cranking advance. Is your timing spot on?
If you set your cranking rpm that high and try to idle at say 850, your engine will always jump between cranking/running settings and this is why it's hunting and you see it in your logs.
When you are cold starting, warmup enrichment and your CL idle targets prevent this from happening, but the solution can't be to idle permanently above 1000rpm or so
If you set your cranking rpm that high and try to idle at say 850, your engine will always jump between cranking/running settings and this is why it's hunting and you see it in your logs.
When you are cold starting, warmup enrichment and your CL idle targets prevent this from happening, but the solution can't be to idle permanently above 1000rpm or so
#8
This can't be right, there must be something wrong with your cranking settings. Try using 0° cranking advance. Is your timing spot on?
If you set your cranking rpm that high and try to idle at say 850, your engine will always jump between cranking/running settings and this is why it's hunting and you see it in your logs.
When you are cold starting, warmup enrichment and your CL idle targets prevent this from happening, but the solution can't be to idle permanently above 1000rpm or so
If you set your cranking rpm that high and try to idle at say 850, your engine will always jump between cranking/running settings and this is why it's hunting and you see it in your logs.
When you are cold starting, warmup enrichment and your CL idle targets prevent this from happening, but the solution can't be to idle permanently above 1000rpm or so
Thread
Thread Starter
Forum
Replies
Last Post