Go Back  Miata Turbo Forum - Boost cars, acquire cats. > Performance & Tuning > ECUs and Tuning > MEGAsquirt > MSPNP
Reload this Page >

Input wiring from break out board to main board

MSPNP MSPNP specific Megasquirt related discussion.
Sponsored by:
Sponsored by:

Input wiring from break out board to main board

 
Old 10-29-2017, 06:21 PM
  #1  
Newb
Thread Starter
 
Join Date: Apr 2016
Posts: 14
Total Cats: 0
Default Input wiring from break out board to main board

I have a Frankenstein'd gen1 megasquirt with ms2 hardware in it. Im trying to set up launch control but it would seem that no matter what input I select in tuner studio, the ms does not see the clutch input. I traced all the wiring and got continuity to ground with the clutch in on pin 13 of the options (center connector in my case) plug. It seems that the input to ms (pin 12) only goes to the bob and not into any of the selectable inputs on the ms. I want to connect the clutch input from the bob to JS7 on the board but am not sure if I just need to make a jumper from the pin on the bob or some other circuit to make the input work. I'll also need another input in the future for table switching for running more timing with methanol.
Attached Thumbnails Input wiring from break out board to main board-img-0016.jpg  
macman2212 is offline  
 


Thread Tools
Search this Thread

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.