i have a the lc-1 wired up how it says to going off the little manual that came with it.

but instead of going straight to the MSPNP2, i tapped into the signal for the stock o2 sensor wire clip. i read somewhere that if you wire directly to the MS, you have to get rid of the stock o2??

my gauge tells me my air/fuel. and seems pretty accurate based of when i was adding fuel to fix my idle problem...

but in Tunerstudio, my air/fuel gauge is either stuck at 10.4 or 7.8? sometimes it bounces between these ranges...

what do i need to do to fix this problem?

thanks in advance!

- larry

 

YOU NEED TO SEARCH!!! AND READ!!!

Seriously, before you make another thread, just search.
These issues you're making new threads about have all been covered at great length, and have extensive writeups available.

Just to show you, here's what exactly 2 seconds of searching yielded:

https://www.miataturbo.net/megasquir...reading-67375/
https://www.miataturbo.net/megasquir...bration-73818/
https://www.miataturbo.net/megasquir...1/#post1012114
https://www.miataturbo.net/megasquir...rstudio-63658/
https://www.miataturbo.net/mspnp-55/...one-use-70810/
There's threads upon threads upon threads.

 

 

thank you!

i got it reading now!