MSPNP2 and sequential spark
#1
MSPNP2 and sequential spark
Hello
Looking to wire up some LS coils and I have it 90% planned and figured out but I jeep finding contradictory info regarding the hardware requirements to run this on my board.
INFO
MSPNP2
v3.57
1994
my question is, can I just use two of the factory spark signals and then just add 2 more signal wires for the remaining cylinders onto 2 of the pins associated with spark output (pins 14-17, and yes I know the is specific like 1342 or something like that)?
Or do I need to free up a spark driver? I read that in order to do sequential spark, need 4 spark drivers, but cant find out for certain whether i have 2 or 4 dedicated spark drivers. In some documentation, it recommends to convert the ALED and/or WLED outputs in order to use their circuits.
Thanks and sorry if this was already answered in another post, but i found contradicting answers and just wanted the up to date perspective on the subject
Looking to wire up some LS coils and I have it 90% planned and figured out but I jeep finding contradictory info regarding the hardware requirements to run this on my board.
INFO
MSPNP2
v3.57
1994
my question is, can I just use two of the factory spark signals and then just add 2 more signal wires for the remaining cylinders onto 2 of the pins associated with spark output (pins 14-17, and yes I know the is specific like 1342 or something like that)?
Or do I need to free up a spark driver? I read that in order to do sequential spark, need 4 spark drivers, but cant find out for certain whether i have 2 or 4 dedicated spark drivers. In some documentation, it recommends to convert the ALED and/or WLED outputs in order to use their circuits.
Thanks and sorry if this was already answered in another post, but i found contradicting answers and just wanted the up to date perspective on the subject
Thread
Thread Starter
Forum
Replies
Last Post