Mspnp2 v1.2 map sensor broken
#1
Mspnp2 v1.2 map sensor broken
I have an mspnp2 on my 90 Miata. Map sensor reads 0 kpa on tunerstudio Does anyone know where I can find a replacement map sensor? I emailed diyautotune and they mentioned i can send a signal to my 20 pin? Coming from a person with limited knowledge, which one is the 20 pin and which type of sensor allows me to send a signal to the 20 pin and work? Thank y'all for the time. Sorry if this was asked already, I tried searching but couldn't find anything about it.
#2
MegaSquirtPNP by DIYAutoTune.com
It's all in the manual.
Move jumper 17. Connect external map sensor to pin 19 on the 20 pin connector.
It's all in the manual.
Move jumper 17. Connect external map sensor to pin 19 on the 20 pin connector.
#3
MegaSquirtPNP by DIYAutoTune.com
It's all in the manual.
Move jumper 17. Connect external map sensor to pin 19 on the 20 pin connector.
It's all in the manual.
Move jumper 17. Connect external map sensor to pin 19 on the 20 pin connector.
For board v1.2 it's this one
MegaSquirtPNP by DIYAutoTune.com
Unfortunately there is no mention of MAP on any of the pins there.
#5
That's for v1.3
For board v1.2 it's this one
MegaSquirtPNP by DIYAutoTune.com
Unfortunately there is no mention of MAP on any of the pins there.
For board v1.2 it's this one
MegaSquirtPNP by DIYAutoTune.com
Unfortunately there is no mention of MAP on any of the pins there.
#7
So I did some multimeter tests and found out that the map jumper links up to 2o which is the maf sensor signal pin. Re reading the email, I realized it says 2O. In the end DIYautotune helped by sending a replacement map sensor which I resoldered on. Since it was a different sensor it pointed upwards, requiring me to drill a hole through the top to route the map line through.
Thread
Thread Starter
Forum
Replies
Last Post
Carloverx
MEGAsquirt
5
07-16-2017 01:38 PM