Just got a bipes ACU, and BEGi FPR in the mail today

315cc PnP Supra injectors are on their way to be cleaned at injector rehab, and a walbro 190hp fp is on the way.


Id post some pics but im sure you all have seen them 100000 times, and both cameras are out of the house atm

Gonna install the Bipes, FPR, FP, and AEM WBo2 sensor i have laying around this weekend, then get the 315s in when they get back.

Probably do the DIY dual feed rail mod while Im in there too.

Think I should go with the RX7 AFM, from what I read the stock AFM should be able to handle the 315s, just wanted to get some opinions.

Ill get some pics up when Im installing ****.

Thanks

 

i saw no benefit with the rx7 afm. other than it being harder to fit....but that's not a benefit is it?

 

Sounds like I will be passing on that then...

Thanks =P

 

put the money toward some engine management!

 

I should of done the DYI dual rail when i had it out. But its not like it takes 5 minutes to take it out.

 

Its gonna come sometime, I just got some pretty good deals on this stuff used, except the FP so i figured I would use this till I got bored again, and sell it and go MS with some 550s...