oil return help: fitting to go into oil pan, what material?
07-06-2007, 03:53 PM
#1
oil return help: fitting to go into oil pan, what material?
I want to make a new oil return line for my greddy setup, but I have a few questions before I go out and get parts.
For the fitting into the oil pan:
- Would brass be ok in regards to thermal and vibrational integrity?
- If brass is ok, what size would be good to get? Greater than 1/2 inch?
For the routing out of the turbo:
- Would copper tubing be ok to work the angles in such a way so that the hose section can be a straight shot to the oil pan instead of coming out towards the frame rail, do a 180* bend on the frame rail, and go into the oil pan?
For the fitting into the oil pan:
- Would brass be ok in regards to thermal and vibrational integrity?
- If brass is ok, what size would be good to get? Greater than 1/2 inch?
For the routing out of the turbo:
- Would copper tubing be ok to work the angles in such a way so that the hose section can be a straight shot to the oil pan instead of coming out towards the frame rail, do a 180* bend on the frame rail, and go into the oil pan?
Reply
0
0
BTW, your signature made me Chuckle, har har :P
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
