shifting issue when car gets hot on track
#1
shifting issue when car gets hot on track
my transmission 6 speed has a hard time shifting once it gets hot, only starts happening after nearly 20 minutes. it starts getting very hard to find 5 gear. I wonder if this could have something to do with the clutch overheating? and not fully disengage? does not seem likely. Ive tried several different oils, right now I have amsoil 75-90 trans oil. I think I need to build a heat shield for the exhaust and or add a temp probe to see what temp this trans gets to on the track.
can I put a temp sensor in the fill plug of the transmission? the drain plug has a magnet and i would rather not delete it. I'm sure the oil is splashing around inside but not sure how much of an affect it will have. guess I should not worry about the magnet since I change the oil pretty offten
any ideas or suggestion?
can I put a temp sensor in the fill plug of the transmission? the drain plug has a magnet and i would rather not delete it. I'm sure the oil is splashing around inside but not sure how much of an affect it will have. guess I should not worry about the magnet since I change the oil pretty offten
any ideas or suggestion?
Last edited by psreynol; 05-07-2013 at 02:36 PM.
#2
I had a similar issue with a slow leak on the slave cylinder. Shifting would get harder about 10-15 min into a session. Downshifting was horrible, it just felt like it was not dis-engaging. My guess is that the old piston seal would warm up and leak more when hot. Never had a problem at normal street temperatures.
Do you have a hard time with all gears or just 5th?
Do you have a hard time with all gears or just 5th?
#3
actually 5th is by far the biggest issue for me. its like once the trans is hot the shifter gets stuck on the gate for reverse or something and you must put the shifter in exactly the right spot or it will not go, versus pretty easy shifting all around at the beginning of the session.
I replaced my master and slave very recently so unless I got a bad one seems unlikely that is my problem. my down shifting is pretty fine.
I replaced my master and slave very recently so unless I got a bad one seems unlikely that is my problem. my down shifting is pretty fine.
#5
[QUOTE=k24madness;1009632]I got the same problem with my 6speed. I am going to try making a heat shield to separate the exhaust heat from the trans. I have to believe it's just the trans getting hot.[/QUOTE
good so I'm not the only one with this issue. well we need to get cracking on this issue, I dont want to destroy my trans.
I've been thinking about the possibility of using a heavy oil or even a oil cooler but if a heat shield works that is a much better solution
I have some material that will make a good heat shield but I would like to double insulate somehow so that when I track, it is the best heat shield i can make. it kinda sucks, no way to reproduce the heat on the street.
good so I'm not the only one with this issue. well we need to get cracking on this issue, I dont want to destroy my trans.
I've been thinking about the possibility of using a heavy oil or even a oil cooler but if a heat shield works that is a much better solution
I have some material that will make a good heat shield but I would like to double insulate somehow so that when I track, it is the best heat shield i can make. it kinda sucks, no way to reproduce the heat on the street.
#6
I just put this on my car today, it's from Thermo Tec...
Clamp-On Heat Shield - pretty easy to put on. My problem is that I'm getting heat soak into the footwell after about 45 min. of freeway driving to/from the track. It's just on the borderline between uncomfortable and slightly painful.
The intention is for this to block the radiant heat while still allowing the exhaust gases to cool enough so the cat doesn't overheat. I've got it on the first part of the exhaust pipe after the downpipe turns towards the rear. I'm also going to do some sort of insulating (this or self adhesive sheet on the tub) where the downpipe passes near the vertical front part of the footwell.
I did change my trans oil over the weekend and it did have a sort-of burned smell to it. Makes sense the trans is getting baked too. Hopefully this helps that as well.
Clamp-On Heat Shield - pretty easy to put on. My problem is that I'm getting heat soak into the footwell after about 45 min. of freeway driving to/from the track. It's just on the borderline between uncomfortable and slightly painful.
The intention is for this to block the radiant heat while still allowing the exhaust gases to cool enough so the cat doesn't overheat. I've got it on the first part of the exhaust pipe after the downpipe turns towards the rear. I'm also going to do some sort of insulating (this or self adhesive sheet on the tub) where the downpipe passes near the vertical front part of the footwell.
I did change my trans oil over the weekend and it did have a sort-of burned smell to it. Makes sense the trans is getting baked too. Hopefully this helps that as well.
#7
[QUOTE=billybobster;1009753]I just put this on my car today, it's from Thermo Tec...
Clamp-On Heat Shield - pretty easy to put on. My problem is that I'm getting heat soak into the footwell after about 45 min. of freeway driving to/from the track. It's just on the borderline between uncomfortable and slightly painful.
yeah I know what you mean, sometimes I get stuck in traffic around Chicago and between my shoes literally melting, and my seat, I would say it is borderline brutal
I mounted a cutting board to the floor and it helped a ton! now it is hardly noticeable.
Clamp-On Heat Shield - pretty easy to put on. My problem is that I'm getting heat soak into the footwell after about 45 min. of freeway driving to/from the track. It's just on the borderline between uncomfortable and slightly painful.
yeah I know what you mean, sometimes I get stuck in traffic around Chicago and between my shoes literally melting, and my seat, I would say it is borderline brutal
I mounted a cutting board to the floor and it helped a ton! now it is hardly noticeable.
#9
This is the **** you want for heat shield material. Heat Master Shields
might try finding something at the pick and pull or perhaps this product is adequate
http://www.blowbyracing.com/heardopish12.html
Last edited by psreynol; 05-09-2013 at 09:30 AM.
#13
Moderator
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 20,701
Total Cats: 3,021
Even the stock exhaust has heat shielding to protect the transmission from the heat. If you are making twice as much power as stock, you are making roughly twice as much heat because you are burning twice as much fuel. I used a cheap IR thermal gun to determine how hot my trans and diff were getting immediately after track sessions and it was scary!
I used exhaust shielding form various sources (junkyard truck exhausts are 2.5-3 inches in diameter) and attached the pieces with worm gear radiator hose type clamps. It cinches down tight and worked well. Sometimes I doubled the clamps together to make them long enough to go around.
I also used the Frost King self-adhesive foam-backed aluminum that is used for home ductwork on the underside of my footwell and part of the tunnel closest to the downpipe and exhaust. After a little cleaning with solvent, it stuck quite well. I bought it at Lowe's. 15 feet by 12 inches for $18. My feet and legs are happier.
I used exhaust shielding form various sources (junkyard truck exhausts are 2.5-3 inches in diameter) and attached the pieces with worm gear radiator hose type clamps. It cinches down tight and worked well. Sometimes I doubled the clamps together to make them long enough to go around.
I also used the Frost King self-adhesive foam-backed aluminum that is used for home ductwork on the underside of my footwell and part of the tunnel closest to the downpipe and exhaust. After a little cleaning with solvent, it stuck quite well. I bought it at Lowe's. 15 feet by 12 inches for $18. My feet and legs are happier.
#14
just ordered 2 of the Thermo-Tec Clamp-On Exhaust Pipe Heat Shield 6" x 24" #11620 inch heat shields for pretty cheap on ebay. easy to work with and should be enough to show heat off the exhaust is causing the shifting problems when hot.. or not. perhaps the turbo itself needs a blanket. one step at a time.
#15
I just returned from a three day track weekend at Thunderhill and got a chance to test my Thermo Tec shields. One went over the downpipe at the bottom and the other on the forward part of the exhaust in the tunnel near the front of the footwell. A little fiddly to put on but a lot easier (I suspect) than trying to get self adhesive sheets in there without removing the exhaust.
My problem was not on track but on the freeway. So my left foot actually felt less heat at 90-95 degrees in the Central Valley last weekend than it did at 65 degrees in Salinas after Miatas at MRLS.
But there's still a ton of heat coming in the cabin overall - so more insulating to do.
My problem was not on track but on the freeway. So my left foot actually felt less heat at 90-95 degrees in the Central Valley last weekend than it did at 65 degrees in Salinas after Miatas at MRLS.
But there's still a ton of heat coming in the cabin overall - so more insulating to do.
#16
I just returned from a three day track weekend at Thunderhill and got a chance to test my Thermo Tec shields. One went over the downpipe at the bottom and the other on the forward part of the exhaust in the tunnel near the front of the footwell. A little fiddly to put on but a lot easier (I suspect) than trying to get self adhesive sheets in there without removing the exhaust.
My problem was not on track but on the freeway. So my left foot actually felt less heat at 90-95 degrees in the Central Valley last weekend than it did at 65 degrees in Salinas after Miatas at MRLS.
But there's still a ton of heat coming in the cabin overall - so more insulating to do.
My problem was not on track but on the freeway. So my left foot actually felt less heat at 90-95 degrees in the Central Valley last weekend than it did at 65 degrees in Salinas after Miatas at MRLS.
But there's still a ton of heat coming in the cabin overall - so more insulating to do.
good info. i dont care if my foot is on fire driving to the track, it already is. I want something that keeps my temps consistent and my trans shifting right for 20 min at full tilt... at a bare minimum, really it needs to work for an hour but right now i dont really care about hot foot. want my car running good first..
i hear you though, its kinda annoying for the street kids
#17
good info. i dont care if my foot is on fire driving to the track, it already is. I want something that keeps my temps consistent and my trans shifting right for 20 min at full tilt... at a bare minimum, really it needs to work for an hour but right now i dont really care about hot foot. want my car running good first..
i hear you though, its kinda annoying for the street kids
i hear you though, its kinda annoying for the street kids
#20
comfort is grand, but I dont think about comfort at all when I'm driving on the track. I think alot about comfort on my way to and from the track because my car is the least comfortable car I've ever driven.
or as Hustler said once to someone who was not having the turbo stud problem..."or maybe you're just driving like a *****. Seriously. Do you go out there for blood or to cruise around and "have fun"? I go to the track because my mother never loved me and I never met my father, and now you have to ******* respect me or I'll wear your face as a ******* mask.
_________________
probably the funnest quote ever about track driving because it is so f-in true.
or as Hustler said once to someone who was not having the turbo stud problem..."or maybe you're just driving like a *****. Seriously. Do you go out there for blood or to cruise around and "have fun"? I go to the track because my mother never loved me and I never met my father, and now you have to ******* respect me or I'll wear your face as a ******* mask.
_________________
probably the funnest quote ever about track driving because it is so f-in true.
Thread
Thread Starter
Forum
Replies
Last Post
SuperSneakySecretSquirrel
Meet and Greet
5
09-06-2015 08:30 PM