So I was trying to figure out why my car was cutting out under certain conditions and a datalog showed that the fuel was cutting out (because I had TOLD it to fuel cut when the boost exceeded the target - DUH!!).

ANYWAY, when I went to revise the Boost Target table on the laptop, TunerStudio wouldn't let me put a value greater than 120kpa into any cell. In fact ANY table where boost or load was referenced, the max value that TS would accept was 120kpa. I could modify tables on my tablet and load that tune successfully with boost/load/MAP values greater than 120 but NOT from this particular laptop.

I figured that there was some setup/configuration value that got corrupted on that laptop somehow, so I wholesale copied project.cfg from another device on the offending laptop, but that didn't work. In fact, when I try to load a copied tune I get the following errors;

So, where is this "limit" coming from and how do I return to normal?

 

I seem to remember a setting under the, general tab, the selection at the far bottom, there something for gauge/chart maximums which you set the maximum rpm, kpa, etc displayed (not aware it sets maximum allowable, but if that fixes it then that is the case).

 

Try looking under Basic/Load Settings->Gauge and Settings Limits, Load/kPa - Max and see if that's where your trouble is:

 

That's IT!! Thanks guys