[fs] clutch master fx400 clutch and mazda GTX clutch
#1
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
[fs] clutch master fx400 clutch and mazda GTX clutch
I have a lightly used Clutch Masters FX400 ceramic 6 puck sprung clutch 10-036-HDCB6, it maybe has 6,000 miles. this clutch should be good for 350 hp, clutch new goes for 500.00 with out fly wheel. i will sell it with flywheel for 275+ 35 shipping con us. the only thing you will need is a throw out bearing, can be used with a miata with the proper throw out bearing
also have a BG GTX clutch, not sure of the mileage but looks extremly low, you can still see the turrn marks in the pressure plate, i would guess low mile like maybe 10k if that. it looks a little dirty from sitting, will sell for 75 shipped con us. i think you may need to use a AWD GTX flywheel with this clutch.
`
also have a BG GTX clutch, not sure of the mileage but looks extremly low, you can still see the turrn marks in the pressure plate, i would guess low mile like maybe 10k if that. it looks a little dirty from sitting, will sell for 75 shipped con us. i think you may need to use a AWD GTX flywheel with this clutch.
`
#3
Senior Member
Thread Starter
iTrader: (12)
Join Date: May 2008
Location: Roselle, Illinois
Posts: 849
Total Cats: -34
yea the clutch masters is a 1.6 clutch, as far as the weight, its a fwd capri fly wheel that has been resurfaced, its heavy id say i think i read some where 22 lbs? i know you can shave them down. with my trans swap i had to run a 1.8 clutch with a 1.8 flywheel
Thread
Thread Starter
Forum
Replies
Last Post
graexodus
Miata parts for sale/trade
5
10-26-2015 01:48 PM