I saw someone posting about downsizing injectors...

I am "upgrading" as it were; being broke, I have the 305cc 80's Supra injectors to replace the stock injectors. While I understand they are undersized for a Super 16G, it's all I have...

Unless. Are most injectors the same dimensions? My now-deceased Mini Cooper S was upgraded to 380cc injectors, and I still have the original 330cc injectors lying around. Anyone have any idea if they would fit on a Miata?

 

you only have three things to consider;

-physical fitment; - they either fit or they don;t

-impedance [low or high]; - what does your ignition expect? does that match the injector? or some stand-alone EMS [e.g.; mega squirt] allow selection to match the injectors

-connector - purchase new connectors if needed

 

t bird super coupes have 370cc's and i believe they are direct fit

 

If you want to run any more than like 5psi on that turbo you'll need to ditch the pos poopra injectors and get at least 460cc

 

most bosch syles will fit. some are a bit too fat to fit down it the head recess. i recommend spending the money for deatch works 440cc with the mtune dual feed rail.

 

...and plug one side of the feed to save money on fittings. BatInc is cheap and has the best quality fittings of anyone I've used.

 

..plug one side? cyl3 and 4 get 1/3 of the fuel they need. a feed from both ends and regulator port is to the side. take a look.

 

heres the pics

 

where did you get that info? im running a stock square escort GT rail with 680cc's now with no problems

 

680cc, what the hell do you need that for, its not exactly a 800hp monster, friend.

well ok, instead of a 440 with dual feed, just do a 700cc with factory ****. your bound to wind up with tons of fuel in it.

it seems your info my good sir it a typical ebay mistake. goodday.

 

injector size is not everything, i just got my id1000s in the mail today. my end goal is only 300whp. i just see it as id rather have too much gas than not enough

 

im around 300whp now. i was maxing my 450cc's out at 85 psi of fuel pressure at only 14 psi of boost(115% duty cycle at redline) now im at 90% on only 50psi of fuel same boost.

i have reasons for goin big friend

 

you are a dumbass and everything you've said thus far is bullshit.
now gtfo out of here noob and don't pollute these threads with your dumbass logic before someone actually takes your retarded advice.

good day sir

 

STFU with your horse-**** gaydom or I'm going to ban you for being a huge ******. Now STFU before you **** off the wrong dude.

 

Plug the FPR and convert. I just switched mine for simplicity.

 

You will only make little over 300hp with 680cc/min. That is still a lot. But no 800hp. Use google and enter "injector calculator". Those tools are quite accurate.

 

I'm pretty sure the Mini Cooper injectors will be a little shorter than the Miata injectors. ...and they will have a different electrical connector.

330cc injectors will only get you to around 200hp before you'd run out of injector.

We have new 350cc, 450cc, and 600cc injector sets that are drop-in fitment for your engine for only $339.

We have an easy to use calculator page on our website: www.deatschwerks.com/fuel-calculators/