Ready to go MS?
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Feb 2006
Location: Mesa, AZ
Posts: 999
Total Cats: 0
Ready to go MS?
I have been reading threads and studdying a bit, but i havent seen any mention of a ready to go MS setup for a miata.. Does anyone offer this? Like a complete built MS, all the sensors and wires and everything you need to go full control, or just ignition and fuel?
#3
Senior Member
Thread Starter
iTrader: (2)
Join Date: Feb 2006
Location: Mesa, AZ
Posts: 999
Total Cats: 0
well i woudlnt mind building one myself... What all did you purchase?? Did you get the megasim thing to test it? I guess if i knew exactly what to buy it wouldnt be so bad. And while asembling it do you have to make any changes to make it work with the Miata?
#4
If I had to do it again I'd buy it pre-assembled from DIY autotune. It wasn't difficult to build, but very time consuming (probably about 10 hours including debugging the serial link). I bought a bunch of unnecessary crap because I didn't read enough before I ordered. The kit comes with male and female DB9/37 connectors, so don't waste your cash buying an extra... I also bought the usb card, usb adapter, usb cable, and serial cable... when I really only needed on half or the other.
Check, DIYautotune.com under the installation articles section for miata specific directions. It's a well written article. If you still don't feel up to it then spend the dough on Kingofleet's plug&play setup.
Check, DIYautotune.com under the installation articles section for miata specific directions. It's a well written article. If you still don't feel up to it then spend the dough on Kingofleet's plug&play setup.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM