Hitting premature rev limiter? AFRs spiking! Scary!!
#1
Hitting premature rev limiter? AFRs spiking! Scary!!
Hey guys,
So a bit of background: It's an NA with a C30-74 on a 80mm pulley.
It's got an intake, header, exhaust, tiny Mazdaspeed intercooler, ID 725cc injectors, Walbro 190 fuel pump, MTX-L, and a MSPNP2.
It was tuned in a previous life, but I bought the car with a blown motor and rebuilt it with a forged bottom end.
With a more conservative timing map loaded, it fired up to life and drove around without a hitch up here in Colorado. It pulled strong and felt great.
I recently just trailered it down to Laguna Seca and it was stumbling and surging at idle. I had to give it gas until it warmed up so it would idle (poorly and surging from 900-1.2k rpm).
The big issue was that it would hit what felt like the limiter at 5.8-6k rpm? I'd watch the AFR spike from 12.5 to 22 and it would stop accelerating. It didn't have an issue running all the way to 7k at partial throttle, but would slam into a limiter every time I was wide open at 5.8k or so.
Here's a link to a log of one of the sessions. I'm sure I slammed into the limiter (if that's what it is) by accident a few times.
http://lols2k.com/stuff/logs/2016-10-01_12.24.45.msl
Anyone have any ideas as to what is happening?
Gonna feel pretty dumb if I pop the fresh rebuild. I've stopped driving it for the time being.
So a bit of background: It's an NA with a C30-74 on a 80mm pulley.
It's got an intake, header, exhaust, tiny Mazdaspeed intercooler, ID 725cc injectors, Walbro 190 fuel pump, MTX-L, and a MSPNP2.
It was tuned in a previous life, but I bought the car with a blown motor and rebuilt it with a forged bottom end.
With a more conservative timing map loaded, it fired up to life and drove around without a hitch up here in Colorado. It pulled strong and felt great.
I recently just trailered it down to Laguna Seca and it was stumbling and surging at idle. I had to give it gas until it warmed up so it would idle (poorly and surging from 900-1.2k rpm).
The big issue was that it would hit what felt like the limiter at 5.8-6k rpm? I'd watch the AFR spike from 12.5 to 22 and it would stop accelerating. It didn't have an issue running all the way to 7k at partial throttle, but would slam into a limiter every time I was wide open at 5.8k or so.
Here's a link to a log of one of the sessions. I'm sure I slammed into the limiter (if that's what it is) by accident a few times.
http://lols2k.com/stuff/logs/2016-10-01_12.24.45.msl
Anyone have any ideas as to what is happening?
Gonna feel pretty dumb if I pop the fresh rebuild. I've stopped driving it for the time being.
#5
Stock coil packs. It wasn't backfiring so it didn't seem like there was excess fuel?
For what it's worth, the car is back home at 5280' elevation and no longer stutters. It runs smooth all the way up to red line.
That being said, I still want to get to the bottom of this because I'd like to track near sea level again soon.
For what it's worth, the car is back home at 5280' elevation and no longer stutters. It runs smooth all the way up to red line.
That being said, I still want to get to the bottom of this because I'd like to track near sea level again soon.
#10
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Your overboost is set at 150kpa. I when you came down to sea level you made "more" boost. Because you were starting at a higher base MAP.
In your logs you hit 151kpa and then fuel cut overboost kicks in.
Turn up overboost, and it wont happen.
Thread
Thread Starter
Forum
Replies
Last Post