Time for a speeduino section!
#11
I've had one for a few years, might as well share some knowledge. When I was first setting it up the wiki/manual was garbage and didn't describe the differences between some settings and this caused a lot of frustration.
When you're first setting up the ve table make sure this option is turned off:
Right now the wiki basically says "don't use this" but it's easy to overlook. It's a very shitty version of o2 sensor feedback that will cause huge lean spikes as it tries to compensate for acceleration enrichment and will constantly be messing with the injector pulsewidth and as far as I can tell there are no options to tune the feedback loop. It's running even when the correction algorithm in the AFR/o2 menu is disabled.
Also, if you have the old MX5 PNP unit straight from the speeduino shop you will find this useful for setting it up on a 1994 1.8:
I see they just added proper support for a/c in the latest firmware version so I'm going to mess with that next.
When you're first setting up the ve table make sure this option is turned off:
Right now the wiki basically says "don't use this" but it's easy to overlook. It's a very shitty version of o2 sensor feedback that will cause huge lean spikes as it tries to compensate for acceleration enrichment and will constantly be messing with the injector pulsewidth and as far as I can tell there are no options to tune the feedback loop. It's running even when the correction algorithm in the AFR/o2 menu is disabled.
Also, if you have the old MX5 PNP unit straight from the speeduino shop you will find this useful for setting it up on a 1994 1.8:
I see they just added proper support for a/c in the latest firmware version so I'm going to mess with that next.
#19
I've had one for a few years, might as well share some knowledge. When I was first setting it up the wiki/manual was garbage and didn't describe the differences between some settings and this caused a lot of frustration.
When you're first setting up the ve table make sure this option is turned off:
When you're first setting up the ve table make sure this option is turned off:
i currently have this on based on their base map
its been working fine.
FYI
Thread
Thread Starter
Forum
Replies
Last Post