Bolt fell out, oops
#1
I EAT CUM
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Redneck, Texas
Posts: 1,198
Total Cats: 0
Bolt fell out, oops
I'm on mile 50 after 6 puck install and it looks like a bolt has fallen out. It is the one just to the right of the two large 17mm bolts up top. It has a 12mm head and is about 1.5" long. I'm guessing that I forgot to finish torquing it down after I did the other 10. I'm supposed to drive to Dallas tomorrow, it should be fine right? All the other bolts are in and torqued down to 85ft lbs.
#3
Elite Member
iTrader: (5)
Join Date: Jul 2006
Location: Central California
Posts: 2,543
Total Cats: 4
that one is for the starter, there are 3 bolts that hold it in place. As I recall, that bolt has a nut on the other end that must be held with another wrench when you tighten it. I would think you should be ok though to drive 50 miles, but i would see if i could either get that bolt out or if not tighten it up just a bit.,
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM