y8s

iTrader: (8)

a little break-in maybe?

ps I meant sam in the navy.

johndoe

iTrader: (5)

Mine did the same, but only when cold and wet. Because it was only in reverse I never cared much to find out why.

NBdriftpilot

no burrrrring sound but right after i put crossdrilled rotors and hawk pads on mine there is a rattle from the front going over bumps but eveything is tight the hell is it

oilstain

I noticed a BRRRRR noise the other day, and I could feel it too. I have just changed all rotors and pads. I'll report in later if the noise continues or ceases. I don't do a lot of driving in reverse, honestly.

Jdmiata

iTrader: (1)

I have the same problem. Every since I swapped in some hawk pads, whenever I turn the wheel while braking to a stop it will make the burrrrrr noise and it shakes the whole car. Doesnt happen all the time but enough where it became annoying.

Meola

I had a similar isssue with my rotors however it was only going forward and I learned that it was when my both my rear calipers siezed up last winter and I was using my front brakes only. I would check you pad and rotor for any type of burring along the edge of the rotor if not it could be possible they werent beded properly or something is slightly loose especially if it only happens in reverse.