DSM T25 Flange Confusion
#1
DSM T25 Flange Confusion
This turbo is off a 97 DSM. I've been told I won't be able to find a manifoldfor it because the mounting flanges on the turbine housing are not common. Just wondering how these two flanges differ from the T25's on Nissan 240's etc. Attached some pics down below. Measured center to center.
Anthony
Anthony
#2
Not letting me do attatchments so check out my post over on miata.net. The pics are there.
http://forum.miata.net/vb/showthread.php?t=223192
http://forum.miata.net/vb/showthread.php?t=223192
#3
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,079
classic garrett vs. mitsu
inlets won't mate, DSM are circles Garretts are square with round corners. plus the sizing is off.
the flanges are also 90* of each other, if you bolt a mistu to a garrett flange, the turbo wont point the way you want it to.
the exhaust flange is completely different.
I might go add some of this stuff to my faq.
inlets won't mate, DSM are circles Garretts are square with round corners. plus the sizing is off.
the flanges are also 90* of each other, if you bolt a mistu to a garrett flange, the turbo wont point the way you want it to.
the exhaust flange is completely different.
I might go add some of this stuff to my faq.
#7
Give Bullseye a call, they MIGHT have something in the way of a different housing to make it work. But at the cost you could probably buy another turbo...
http://www.bullseyepower.com/turbines.php
http://www.bullseyepower.com/turbines.php
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM