elior77

I use a volvo TD04H-13C turbo

Compressor:
Inducer 40mm
Exducer 53mm (!)

Turbine 52mm

I would like to upgrade to 19T compressor, that will give me:

Inducer 46mm
Exducer 58mm

Turbine 52mm (not replacing)

I have found this:


Kinugawa Mitsubishi Turbo TD04 TD04H TD04HL Billet 19T Compressor Housing + Billet wheel & Blow Off Valve(BOV)

Will it fit ?

Thanks !

sturovo

Not sure for the 13C... but it is necessary to increase the width of the exducer recess on 13t CHRA's when fitting 19t wheels.

sturovo

In any case 19t's are too small. You need the 23t

elior77

What do you mean "increase the width of the exducer recess" ?

sixshooter

iTrader: (12)

He's talking about the cut out in the backing plate behind the compressor that the compressor sits down into.

elior77

Better ?

Turbo CHRA Upgrade Kit VOLVO S70 850 TD04HL-20T Monster

Will fit ?

acedeuce802

iTrader: (1)

FYI, here's my TD04HL-20T with a 6cm Kinugawa turbine housing. This is the Mitsu 20t that comes on the Caliber SRT4, not the billet wheel. 3" DP and the rest is 2.5" back, no cat. I didn't quite have my EBC tuned fully yet. It'll hit that 9 psi at 3000 rpm now.

Leafy

iTrader: (1)

Yes that will work, but its not much more money to just get the whole turbo with a new exhaust housing so you can sell your current turbo.

That 20t dyno is kind of depressing, those are the peak numbers I'd expect out of a 13t, is the motor ok?