Almost there! :)
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2006
Location: So Cali
Posts: 98
Total Cats: 0
Almost there! :)
hey guys.. i was going to install my turbo and everything last night when i noticed that the bolts i had for my turbo manifold were rusted i was going to use them anyways.. but my "friends" had to beat me to the ground to stop me haha. my question to you guys is this.. where is a good place to buy the bolts for the manifold? i remember my friends telling me i need bolts that exceed grade 8 or something like that. it would be great if you guys gave me the bolt/thread size too. sorry for being such a newb
thanks!
thanks!
#7
Whaddya mean bolts? Do you mean "Studs"... the short rod threaded on both ends that screw into the manifold, but hold the turbine housing to the manifold with nuts?
You've gotta know the thread pattern... my Begi uses M8x1.25 and my Garrett turbine housing also had that size.
I called Begi and Stephanie sent me a dozen for about $10.
You've gotta know the thread pattern... my Begi uses M8x1.25 and my Garrett turbine housing also had that size.
I called Begi and Stephanie sent me a dozen for about $10.
Last edited by samnavy; 08-01-2007 at 09:35 PM.
#9
Whaddya mean bolts? Do you mean "Studs"... the short rod threaded on both ends that screw into the manifold, but hold the turbine housing to the manifold with nuts?
You've gotta know the thread pattern... my Begi uses M8x1.25 and my Garrett turbine housing also had that size.
I called Begi and Stephanie sent me a dozen for about $10.
You've gotta know the thread pattern... my Begi uses M8x1.25 and my Garrett turbine housing also had that size.
I called Begi and Stephanie sent me a dozen for about $10.