Oil supply restrictor
#1
Oil supply restrictor
Hey guys i just got my turbo running, but it seems my oil supply line is too big and is putting too much oil pressure into the T-25 turbo. Im running a -4an line and i need to run a -3an. Does anyone know where i can get a 10mmX1.5 to -3an adapter to use on my block? Or something that would reduce the pressure on a -4an line. Im so close to finishing this turbo and it's killin me to have these little problems.
Thanks!
Thanks!
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,508
Total Cats: 4,080
Buy a restrictor.
I run this one personally:
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
or if you are gung-ho on running a -3an line then:
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
I run this one personally:
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
or if you are gung-ho on running a -3an line then:
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
#6
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,508
Total Cats: 4,080
K, what about this instead.
http://www.extremepsi.com/store/cust...cat=336&page=1
screw that into the turbo and the line right into that. Might want to get a 90* fitting
http://www.extremepsi.com/store/cust...cat=336&page=1
screw that into the turbo and the line right into that. Might want to get a 90* fitting
#8
atp had what you were looking for as well, shoulda found it if you looked in the oil supply section
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM