removing injectors
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
removing injectors
Hey Everyone.
I am going to replace my injectors with bigger ones. So my question is, will i have to remove the intake to get the old injectors out? I would really rather not to.
Thanks
I am going to replace my injectors with bigger ones. So my question is, will i have to remove the intake to get the old injectors out? I would really rather not to.
Thanks
#4
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
I still need some help. Can someone post their settings for 550cc injectors? It looks like there is a lot of things like cranking pulse width and such that need to be changed. So its nice if someone can post rough numbers that are close to my set up.
#7
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
um i can throw u my msq if you like its decent i dont think you are brave enough to run my timming yet though Damn i just checked its on my other laptop, i will post it when i get to the other one probly in the morning. In the meantime maybe someone will uplaod a tune for you.
#14
Elite Member
iTrader: (21)
Join Date: Jun 2006
Location: Point Pleasant, NJ
Posts: 2,957
Total Cats: 2
RE: your AFR targets Magna. I run mine the opposite of that left to right. Meaning I run richer to 3500 then lean out. My thinking was rich = more torque so lets throw some extra at it down low to get this bitch moving. Well it certainly does move.
Isn't 12.4AFR a lil lean to run at 10-11 lbs of boost?
Isn't 12.4AFR a lil lean to run at 10-11 lbs of boost?
#17
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
ok, i got the injectors in. It was easy but for some reason they are like half an inch shorter than the stock. But they dont leak. I did have to change the cranking to get the car started. I scaled the VE table much leaner. The car runs great, but i think i need to work on the acceleration enrichment. When i press on the gas slowly the car runs great but if i stomp on it the wideband goes to like 9.3 and the car stutters. Where the hell do i find Acceleration Enrichment?
#19
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2008
Location: Minneapolis, MN
Posts: 963
Total Cats: -1
its for sure accel enrichment pw. i can guarantee you that. it was running fine with stock injectors. It does it no matter what afrs i am at. Cruising at 2500 at 14.5-15.5 or going in 2nd at 4500 at around 13.8. It just dips right to 9 and goes back to 11.5 or so in boost.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM