workin on the car so i took some shots
04-29-2008, 11:48 AM
#23
Junior Member
Thread Starter
Join Date: Mar 2008
Location: Western mass
Posts: 271
Total Cats: 2
It is filler that is used around heat... good to 600* before it ignites 
and the cam gear backing plate is off because I made that plate.. and i wanted people to see what I made. I readjusted the cams afterwards and have been buttoning up the engine compartment slowly but surely
and the cam gear backing plate is off because I made that plate.. and i wanted people to see what I made. I readjusted the cams afterwards and have been buttoning up the engine compartment slowly but surely
Reply
0
0
04-29-2008, 11:56 AM
#24
Junior Member
Thread Starter
Join Date: Mar 2008
Location: Western mass
Posts: 271
Total Cats: 2
none ran down. and it is very easy to remove... for instance i just removed the power steering... and you all know about the dumb line that runs to the front of the car.. well I used that stuff to block off the air on the bumper too. So that line had that stuff on it and it was also stuck to the tin. I pried it off with the force of a 2yr old with a flat head.
as for it running down, when you stray it it immediately expands and is heat resistant. Available at Home Depot! replacing the fan is not a problem... I think im going to put an oil cooler right infront of the fan on the right in that pic.
as for it running down, when you stray it it immediately expands and is heat resistant. Available at Home Depot! replacing the fan is not a problem... I think im going to put an oil cooler right infront of the fan on the right in that pic.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Jike Spingleton
Cars for sale/trade
3
09-20-2016 04:33 PM
