Interior Decorating
#1
Elite Member
Thread Starter
iTrader: (16)
Join Date: Aug 2007
Location: Houston, TX
Posts: 9,302
Total Cats: 481
Interior Decorating
My wall of parts:
http://s231.photobucket.com/albums/e...Valve%20Cover/
What should I add next? I'm trying to figure out how to hang the SC on there, but it's heavy. I'll have to hit studs and use string like i did on the header to support it.
http://s231.photobucket.com/albums/e...Valve%20Cover/
What should I add next? I'm trying to figure out how to hang the SC on there, but it's heavy. I'll have to hit studs and use string like i did on the header to support it.
#9
Thanks Paul. I bought the fugly yellow one off Pat. It'll be coated in a more appropriate color once I get it.
So I suppose I need a Protege valve cover gasket to go with it, eh? And fab up a braket to mount my coil packs, and reroute the vaccum hose that's now on the driver side of the VC, to the back where the Protege one is. Anything else I should be aware of?
C
So I suppose I need a Protege valve cover gasket to go with it, eh? And fab up a braket to mount my coil packs, and reroute the vaccum hose that's now on the driver side of the VC, to the back where the Protege one is. Anything else I should be aware of?
C
#10
There is a process to getting it to fit right.... and i have done it a few times.
Take all internal baffles out and clean throughly.
Using a mallet, hit the breather nipple back INTO the valve cover, it will fall out nicely.
Now find a large screw to put in that hole. The trick is to tap out the hole and cross-thread a bolt in the old breather location, put it on from the inside out, this way you don't have a bolt head on the outside. Cut off excess threads and smooth down.
I forget what size drill bit you need, but drill a hole where you see the yellow X in this picture. Then use a rubber mallet to gently press the breather fitting back into the valve cover.
Then make a small 90* elbow to hold the coil-pack onto the valve cover. You can see it here on the pax side.
Take all internal baffles out and clean throughly.
Using a mallet, hit the breather nipple back INTO the valve cover, it will fall out nicely.
Now find a large screw to put in that hole. The trick is to tap out the hole and cross-thread a bolt in the old breather location, put it on from the inside out, this way you don't have a bolt head on the outside. Cut off excess threads and smooth down.
I forget what size drill bit you need, but drill a hole where you see the yellow X in this picture. Then use a rubber mallet to gently press the breather fitting back into the valve cover.
Then make a small 90* elbow to hold the coil-pack onto the valve cover. You can see it here on the pax side.
Thread
Thread Starter
Forum
Replies
Last Post
russian
Miata parts for sale/trade
6
10-08-2015 03:01 PM