blaen99

iTrader: (6)

Great to hear more converts of it ;b.

Dynamat/fatmat/etc. does wonders for the Miata!

soviet

iTrader: (10)

Scott, is that recorded with a DSLR + wide angle? I can't get angle that wide with my contour, lol.

soviet

iTrader: (10)

Dunno about quietness but teh cat would catch the chunks of your turbine wheel

Braineack

iTrader: (62)

yeah, it was at like 15mm. it could go wider...

EO2K

iTrader: (37)

So, does anyone have a clip of a 5x11x22 on a supercharged or NA car?

Nagase

iTrader: (6)

I might in about 7 weeks, depending on Abe@ARTECH.

Orion ZyGarian

Uhhh...well I have a 4 x 9 x 18" according to some site. I just have a stock setup and Magnaflow catback, and am VERY happy with it. Has a 4 x 14" resonator as well, but being N/A, its 2.25" piping. I have a video or two and have been meaning to make more, if you really want to hear it

Ian

iTrader: (2)

Curious about this as well

triple88a

iTrader: (2)

I dont have a clip however when i ran mine on an open wastegate it was a little loud on a 3" exhaust, not rice civic loud but definitely loud enough to hear over the passenger at a quiet conversation while cruising (no drone though). I'd suspect it's a little louder on a freeier exhaust. It sounded good though.

kmvguy

Bringing this one back from the dead.

I really like to try these muffler, and I was wondering which 5x11x22 magaflow you guys are using. Seems like there are 3 types, center/center, center/offset, offset/offset.

Schuyler

iTrader: (1)

The center/center one is dual chamber if I'm not mistaken. So quieter than the center/offset ones.

triple88a

iTrader: (2)

Depends on how tight of a bend you can get your hands on and whos making you the exhaust. I had mine made and the yeah they tried to use crush bends instead of the mandrel bent pipes like they promissed.. I had to buy my own bend so they can fix my exhaust.

If you can get ur hands on tight bends, go with center center, if not offset offset.

DNMakinson

iTrader: (3)

If you get the center-offset, it is not directional. So, you can choose any of 3 positions for the inlet. The outlet just goes to tailpipe so it will always work.

That being said, center requires tight bends, offset to rear works with long radii, offset to front, I can't see how to make it work.

DNMakinson

iTrader: (3)

Double post