seriously fed up...someone help!
#1
seriously fed up...someone help!
right went out today aftyer running tunerstudio and its running liek a sack of **** again.
im seriously fed up with this.
i dont know what to do, everytime i change something somethign else ***** up.
excuse the french but im seriously ticked off now.
iv spent 5 months rebuilding the whole bloody car and i cant get it to run right.
please can someone advice.
holding revs is terribel especially below 3000 rpm it splutters and splatters and judders around.
there a several points throughout the rev range where it does the same.
iv tuned the map on tunerstudio but im not getting anywere im going one step forward 2 steps back
would an msq help? if so please can someone talk me through how to do it.
im seriously fed up with this.
i dont know what to do, everytime i change something somethign else ***** up.
excuse the french but im seriously ticked off now.
iv spent 5 months rebuilding the whole bloody car and i cant get it to run right.
please can someone advice.
holding revs is terribel especially below 3000 rpm it splutters and splatters and judders around.
there a several points throughout the rev range where it does the same.
iv tuned the map on tunerstudio but im not getting anywere im going one step forward 2 steps back
would an msq help? if so please can someone talk me through how to do it.
#6
right finaly got a data log
hope it is what you need to help me.
Download 2011-04-28_14.10.59.msl from FileFactory.com
hope it is what you need to help me.
Download 2011-04-28_14.10.59.msl from FileFactory.com
#8
Senior Member
iTrader: (7)
Join Date: Sep 2009
Location: Royal Oak Michigan
Posts: 754
Total Cats: 68
right finaly got a data log
hope it is what you need to help me.
Download 2011-04-28_14.10.59.msl from FileFactory.com
hope it is what you need to help me.
Download 2011-04-28_14.10.59.msl from FileFactory.com
#9
Senior Member
iTrader: (7)
Join Date: Sep 2009
Location: Royal Oak Michigan
Posts: 754
Total Cats: 68
Ok from the mess of a log- Your fuel is a complete mess. Where did you get your map?
At around 47kpa and 3000 rpm you have just about zero fuel. This will cause the "splutters and splatters and judders around".
Are you using the AFR Target table? If so, it's telling the car to go lean. The target table is a mess. Disable it until you've worked out your fuel. There are other issues though. Just upload your MSQ file.
At around 47kpa and 3000 rpm you have just about zero fuel. This will cause the "splutters and splatters and judders around".
Are you using the AFR Target table? If so, it's telling the car to go lean. The target table is a mess. Disable it until you've worked out your fuel. There are other issues though. Just upload your MSQ file.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
7
09-24-2015 03:50 PM
JasonC SBB
Insert BS here
3
11-03-2008 04:55 PM
naarleven
Insert BS here
5
10-26-2008 12:19 AM