MSQ please...
#1
Elite Member
Thread Starter
iTrader: (11)
Join Date: Apr 2007
Location: VA Beach
Posts: 1,996
Total Cats: 51
MSQ please...
I got a friend replacing a 1.6 turbo motor with a 1.8 (stock) NA motor and was using MSI 2.25 MS/E HR10. I only have a MSQ for the turbo setup, anyone got a 1.8L NA tune I can start with?
Using 1.6 coils
GM AIT sensor
Currently no IAC but will be wired up ASAP
No TPS
Thanks
Mike@icantdo55.com
Using 1.6 coils
GM AIT sensor
Currently no IAC but will be wired up ASAP
No TPS
Thanks
Mike@icantdo55.com
#3
Senior Member
iTrader: (4)
Join Date: Jan 2008
Location: Falls Church, VA
Posts: 1,361
Total Cats: 17
This is one of the last decent msqs I have saved from when I was running MS1. This is for a n/a 1.8 with the stock 265cc injectors. I was running Hires 10g, and it was a parallel install so you will need to configure any settings for idle as I had the stock ECU doing that. Judging by the dwell settings, I was using the stock 1.8 coils here. Not sure what, if anything, would be different about the 1.6 coils. Also I was using TPS-based accel enrich so you will have to switch that to MAPdot until you get a TPS.
#4
Elite Member
Thread Starter
iTrader: (11)
Join Date: Apr 2007
Location: VA Beach
Posts: 1,996
Total Cats: 51
This is one of the last decent msqs I have saved from when I was running MS1. This is for a n/a 1.8 with the stock 265cc injectors. I was running Hires 10g, and it was a parallel install so you will need to configure any settings for idle as I had the stock ECU doing that. Judging by the dwell settings, I was using the stock 1.8 coils here. Not sure what, if anything, would be different about the 1.6 coils. Also I was using TPS-based accel enrich so you will have to switch that to MAPdot until you get a TPS.
Thread
Thread Starter
Forum
Replies
Last Post