FS: Custom 1.6 B6 Intake Manifold
11-04-2013, 12:19 PM
#1
FS: Custom 1.6 B6 Intake Manifold
Looking to sell a custom intake manifold for the B6 made from aluminum. I've been on here for a grip, but don't post much. I apologize if I need to add more documentation to my threads. mods please let me know and I will provide.
From what I have researched the plenum was made made from sheet, and was welded to the stock 1.6 plenum so stock fuel rail can be used. The velocity stacks were made in house from machining, and the intake was custom welded with sheet. Can bolt on stock fuel rail.
At some point the manifold was rewelded to fix some cracks. I also cleaned it up some and also saw some jb-welded areas. The detail of this can all be seen in the VERY LARGE pictures below. I received this manifold in trade and it's a little too much for my power goals.
$280 Shipped or best offer. I'm located in SW Ohio.
Price dropped $350 to $300 11/6/2013
Price dropped $300 to $285 11/8/2013
Price dropped $285 to $280 11/11/2013
Top
Bottom
The manifold has a bit of history and I believe it was made by MT member Splitime.
Miata Turbo Forum - Turbo Kitten is watching you test compression. - View Profile: Splitime
Below is the original for sale thread that he made
https://www.miataturbo.net/miata-par...anifold-51478/
The below pictures are from his photobucket. I've sent a request to ask him if I can use them. If by request he would like me to remove them I will.
From what I have researched the plenum was made made from sheet, and was welded to the stock 1.6 plenum so stock fuel rail can be used. The velocity stacks were made in house from machining, and the intake was custom welded with sheet. Can bolt on stock fuel rail.
At some point the manifold was rewelded to fix some cracks. I also cleaned it up some and also saw some jb-welded areas. The detail of this can all be seen in the VERY LARGE pictures below. I received this manifold in trade and it's a little too much for my power goals.
$280 Shipped or best offer. I'm located in SW Ohio.
Price dropped $350 to $300 11/6/2013
Price dropped $300 to $285 11/8/2013
Price dropped $285 to $280 11/11/2013
Top
Bottom
The manifold has a bit of history and I believe it was made by MT member Splitime.
Miata Turbo Forum - Turbo Kitten is watching you test compression. - View Profile: Splitime
Below is the original for sale thread that he made
https://www.miataturbo.net/miata-par...anifold-51478/
The below pictures are from his photobucket. I've sent a request to ask him if I can use them. If by request he would like me to remove them I will.
Last edited by Meeners; 11-11-2013 at 09:02 AM.
-1
11-06-2013, 02:36 PM
#7
That I am not sure of. I mocked it up and planned to go down through the fender wall and forward, but if you aimed your pipe forward in the bay like shown in the pictures I believe it would hit the lights.
0
Thread
Thread Starter
Forum
Replies
Last Post
