Couple of Questions B/F I Buy a 6 Speed and Torsen
#1
Elite Member
Thread Starter
iTrader: (6)
Join Date: Sep 2007
Location: CA
Posts: 2,016
Total Cats: 13
Couple of Questions B/F I Buy a 6 Speed and Torsen
2002 3.9 Torsen
I will get:
-ABS 1 piece axles (2)
-Diff w/ carrier
-Driveshaft
1) Will this fit fine on a 1.6? I read a post from Hustler:
"I don't know if the spline diameter issue is discussed anywhere, but the ones from the '00 swap car, which I pulled out of a rear subframe did not fit the 1.6 hubs because the spline teeth were too tall."
2) I don't have ABS. These axles WILL have ABS. Any problems w/ this?
2002 6 Speed Trans
I will get:
-Tranny
-Tranny plate
-Shifter
1) Have I overlooked any parts for the tranny swap? Anything for speedometer correction needed?
I will get:
-ABS 1 piece axles (2)
-Diff w/ carrier
-Driveshaft
1) Will this fit fine on a 1.6? I read a post from Hustler:
"I don't know if the spline diameter issue is discussed anywhere, but the ones from the '00 swap car, which I pulled out of a rear subframe did not fit the 1.6 hubs because the spline teeth were too tall."
2) I don't have ABS. These axles WILL have ABS. Any problems w/ this?
2002 6 Speed Trans
I will get:
-Tranny
-Tranny plate
-Shifter
1) Have I overlooked any parts for the tranny swap? Anything for speedometer correction needed?
#2
Former Vendor
iTrader: (31)
Join Date: Nov 2006
Location: Sunnyvale, CA
Posts: 15,442
Total Cats: 2,099
You'll need a speedo gear, a 4:10 speedo gear will be most accurate with the 3.9s. Dead on up to around 100mph. I've never heard of '02 axles not fitting in 1.6 uprights. Push comes to shove, you source earlier axles.
Thread
Thread Starter
Forum
Replies
Last Post
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM