Anyone know of thinner (diameter) unflanged nuts?
#1
Anyone know of thinner (diameter) unflanged nuts?
Right now I only have 2/3ish threads of engagement holding on one of the studs of my downpipe. It's an M8 stud, I'm looking for a reduced hex nut... found one with a flange, but that makes it even worse than this. Any recommendations?
(as an aside, anyone know the part numbers to get a steel oil tee from pegasus racing? I'm not finding the correct adapters)
#9
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
then you fit the nut on it as your fitting the manifold onto the studs. So you'll have to "float" the flanges apart and start getting the nut threaded, then get the surfaces to mate up as you tighten the nut.
#10
Right now I only have 2/3ish threads of engagement holding on one of the studs of my downpipe. It's an M8 stud, I'm looking for a reduced hex nut... found one with a flange, but that makes it even worse than this. Any recommendations?
(as an aside, anyone know the part numbers to get a steel oil tee from pegasus racing? I'm not finding the correct adapters)
grind the flange down?
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM