Eric Risinger

I have FM's downpipe, a racing beat cat delete, and a magnaflow catback I got off a guy who had it on his 1.6. Problem is, it doesn't fit very well. I've included a link to some pictures. It hits the rear axle and routes straight up, into the rear sway bar. I can pull it down a little, but it stresses the exhaust system. It really needs to come down a couple of inches/degrees. What do I do?
Thanks
https://imgur.com/a/rlDopK4

Eric Risinger

Update: I've gotten the exhaust on through a wonderful method called Pull Really ******* Hard™
I hate how much stress is on the system and the fact that the muffler is contacting the bottom of the trunk but whatever, it's in

rleete

iTrader: (21)

That looks way too close to the axles. It's gonna rub over any kind of bumps.

curly

iTrader: (25)

Buy new exhaust? It’s that or modify what you have. But see above, it’ll just rub

aju41046

Take your end pipe to an exhaust shop and have them bend it down a few degrees

2manyhobyz

iTrader: (4)

Yep, pretty easy to just heat the spot in the pipe to change curve/angle to get what you want. If done correctly the hangers will have little stress also. If you go to a shop insist on looking before letting it down.