couple of noob questions, need some help on turbo install
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2009
Location: illinois
Posts: 183
Total Cats: -4
couple of noob questions, need some help on turbo install
So i have a oil feed line kit that is only 36 inches long, and i dont think that it is long enough. Btw the car is a 99. And comes to find out that the thread that goes onto the block where the oil pressure sensor goes is a npt and not a bsp. I'm going to see if there is another type of thread that i can just get at the hardware store to mate to the t fitting. Is 36 in long enough and should I route it under the motor, or over? also my lc1 wideband is comming tomorw, so would i just get another bung for it and weld it onto my pipes and retain both of the factory o2 sensors. So i would have a total of 3 o2 sensors and run the lc1 independently of anything. I also got the lc1 adaptor to go to the adaptronic. and not completly sure of what to do at this point.
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,027
Total Cats: 6,592
Is this a Mazda BP engine, or a Chevy LS1? I'm almost 100% certain that all the B-series blocks used a 1/8" BSP thread at the oil pressure sensor.
Anyhoo, anplumbing.com is a great source of parts and hose for relatively cheap. So is your local industrial hydraulic hose guy.
Anyhoo, anplumbing.com is a great source of parts and hose for relatively cheap. So is your local industrial hydraulic hose guy.
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM