This is to connect a 1.25" bung on my intake, to my BOV which has a 1" bung...

Where do I get one?

 

Stretch the 1" over the 1.25" bung? Get a pot of boiling water and heat it up, I'm sure it'll go.

I have no idea if you can get a 1 to 1.25 transition anywhere. Maybe look at an autoparts store, some OEM might use a oddball heater hose.

 

I think you emailed me at my personal gmail account. We have them, I can get you a price on Monday.

 

It's next Monday already.

 

Damnit!!!!!! Tomorrow...

 

haha, you suck as a salesman. :gay:

 

for real! WOT would have had the **** at his house already.

 

Ryan? Is he on here?

I'm not on here as a salesman, I'm just doing you choads a favour.

 

Pat, I apologize, the BOV bung is 0.83" - so I need a 3/4" to 1.25" hose - do you have that?

 

.83" is 7/8ths isn't it? 21mm or so. I have 28-22mm, 1-1/8th to 7/8ths. Two bucks cheaper.

 

What kind of valve are you using?

 

Sorry for sitting on this forever

I need a 1-3/8 to 7/8 adapter hose. Do you have one?

The BOV is an AVO unit, and my AVO ic has a 1-3/8" bung on the pipe; the
i/c is meant to replace an FM i/c in an FM kit.

 

We don't make that size :(

 

put a length of hose on the 1-3/8 hose, sticking out an inch or so. then insert a 1"length of 7/8 hose inside of the 1-3/8 hose, then insert your bov, then clamp down on the whole thing.

 

I have a 5$ solution that I did just the other day and it works fine. I got a 90* copper bend in the 1" size. Many of these fittings are larger on one side than the other so that piping can slip into it. Then for a 1" coupler go to the rubber hose section and I found a super heavy duty red hose that looks the same as what Im using for the drain on my turbo. Short piece of that did the trick. Then finally I used some bailing wire to add some extra security if said bov ever falls off.