opinions of jgs precision manifold
#21
I run one.... it's ok..... could be better...... I think the flange is warped from the welding (I didn't weld it) and I have a slight exhaust leak that I can't solve.....
We added the external wastegate much in the same location as BEGI did.....
man I want the bell manifold and downpipe for my T3 setup! wonder what it costs...... I know the manifold is over 500......
We added the external wastegate much in the same location as BEGI did.....
man I want the bell manifold and downpipe for my T3 setup! wonder what it costs...... I know the manifold is over 500......
#24
Yes on the powersteering.
My DP and IC pipes were made by Race Related in St Petersburg. The guy who runs the place is a very good welder. The DP is basically a cast iron diesel flange bored out to 3" and connected to a stainless 3" pipe. There is a v-band clamp connecting it to a 3" exhaust which runs to a bullet muffler at the rear bumper.
My DP and IC pipes were made by Race Related in St Petersburg. The guy who runs the place is a very good welder. The DP is basically a cast iron diesel flange bored out to 3" and connected to a stainless 3" pipe. There is a v-band clamp connecting it to a 3" exhaust which runs to a bullet muffler at the rear bumper.
#28
Yeah, i get the idea of most of it from that photo, i was just curious if you had one of it out of the car. It doesn't matter I'm pretty sure I know how it is shaped. Did it all fit good or did you have to remove some material from the chassis? It appears to all fit but because of the angle I can't quite see the clearances with the side wall and all that. Have any facing down?
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM