My hella rice intake that I did two days ago. It's like air ducting that they sell at the rice section of autozone, 3" diameter with 2 hose couplers included. That's the only thing that I could use for my intake, for now.

http://www.autozone.com/servlet/UiBr...ESPE%7C%7Etrue

 

I'm using the same thing in blue

 

Don't feel bad, I must admit that I used that same tubing on my JRSC setup.
-Michael-

 

That looks so nice, I need to wire tuck but I have so much **** to tuck its not even funny.

 

nice job andy

 

Thanks dude. When is your rag gonna run again?

 

i got her out today 6psi so far so good. yeah she is nice and used looking ads to the sleeper image. Homemade paint job skills homemade turbo no IC = they think i dont know what im doing. makes the look of surprise in the rearveiw all the better. but you know about that dont ya, im sure youve seen it on quite a few fbodys etc.

 

I've been trying to figure out a way to get my afm turned around like that, if it holds pressure well I can give it a shot. My turbo is like 1.75 so its kinda bitch to get sized right. and the afm side is just slightly over 2" so... I was thinking I could swing some 2" flex pvc to get the bend there... a little connector from the turbo to get the size.

 

Just get a damn IC and paint it black

 

+1 on the crouching miata hidden intercooler.

krylon semiflat
http://jazz.sdsc.edu/photo/photo.php...s_100_0359.JPG

 

I need to reduce it to like 2" or 2 1/4" so I just used double layer of hose couplers, 2.5" inside of the 3". It's not gonna hold pressure, but for the intake it won't leak/suck any air behind the afm.

 

Is your oil feed comming in side ways? that doesn't seem to healthy

 

Rusman,

How is the Intake ducting holding up? I wonder if it will deform while the suction is so great.

 

Way to bring back the dead. Magna needs another hobby.

 

no problems with it, it was made for it.

 

Beautifully clean!!

 

reminds me, I still need to get the dead leaves out of the front fenders.