Will I need a machinist for these H-Beams
#1
Will I need a machinist for these H-Beams
So what began as a simple DIY build has turned into some real fun for me.
I have a garrett T28 off a nissan Rice-14 in the area, still figuring out what to do with manifold/DP/intercooler.
So I was aiming at new rods for 200hp just for ***** and giggles and so I can have an excuse to pull off the head to see the condition of the cylinder walls for any scoring I could hone out.
I've been reading on the Belfab/ETD rods and although they are great for the price, will I actually need to find a machinist in the area to hone them down to spec? It isnt the quality of the product im questioning, but the consistency.
I know from many a honda engine that Carillo rods will fall right into place, but they are so damn expensive.
So bottom line. What are the chances that I can just seat the ETD/Belfab rods perfectly fine and not have any problems?
I have a garrett T28 off a nissan Rice-14 in the area, still figuring out what to do with manifold/DP/intercooler.
So I was aiming at new rods for 200hp just for ***** and giggles and so I can have an excuse to pull off the head to see the condition of the cylinder walls for any scoring I could hone out.
I've been reading on the Belfab/ETD rods and although they are great for the price, will I actually need to find a machinist in the area to hone them down to spec? It isnt the quality of the product im questioning, but the consistency.
I know from many a honda engine that Carillo rods will fall right into place, but they are so damn expensive.
So bottom line. What are the chances that I can just seat the ETD/Belfab rods perfectly fine and not have any problems?
#3
My Eagle H-beams needed to be machined.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote
#4
Even the mortgage-priced carillos? I thought that was the point of spending that much? Although to be honest, It probably is fair because the clearances on a 93k motor are going to be much lower thant he bearings associated with these new rods spec'd to stock size
Do the ETD/Belfabs have the notch to squirt oil to the wrist pins? That must look badass in action. My friend with a Jetta build has rods with those and I got a bit jealous.
Who here has used them without a bit of maching and found success? I think its like 200 bucks in this area to have rods worked over
Do the ETD/Belfabs have the notch to squirt oil to the wrist pins? That must look badass in action. My friend with a Jetta build has rods with those and I got a bit jealous.
Who here has used them without a bit of maching and found success? I think its like 200 bucks in this area to have rods worked over
Thread
Thread Starter
Forum
Replies
Last Post
skou
Miata parts for sale/trade
4
09-10-2015 09:44 AM
Der_Idiot
Engine Performance
12
09-03-2015 03:31 PM
M-Tuned
Miata parts for sale/trade
24
02-29-2008 11:56 PM