99 ms3x drop in solution?
#1
Elite Member
Thread Starter
iTrader: (7)
Join Date: May 2007
Location: Dallas, Tx
Posts: 3,006
Total Cats: 103
99 ms3x drop in solution?
Is there a drop in pnp solution for 99? I see the ecu for $640 and MegaSquirt Wiring Harness for $78.
Or am i just dumb and it's really that easy as ting into the wiring under the dash that would be going to the stock ecu?
Or am i just dumb and it's really that easy as ting into the wiring under the dash that would be going to the stock ecu?
#3
Tour de Franzia
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
You want full stand alone with a pnp harness, wired for sequential fuel. It's not like that thing will come remotely close to posting OBDII readiness codes.
Does anyone care to share their MS3x MSQ for a 99? I'm trying to figure out how to set-up the crank trigger, cam sync, and sequential fuel.
That car is really going to rip now.
Does anyone care to share their MS3x MSQ for a 99? I'm trying to figure out how to set-up the crank trigger, cam sync, and sequential fuel.
That car is really going to rip now.
#9
Tour de Franzia
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
- You have a GM IAT
- You have an LC-1
- You have a MAP hose run
- You have VICS wires laid
- You need the assembled MS
- You need a wiriing solution which I don't have the answer to (I vote for Boomslang pig-tail. If the guy who builds the computer wants to give me wiring directions, and he promises they will work, then I'll save you $80 and solder it into the harness and chop-off the factory connectors.
I bet you a case of Shiner that I'll have this car ready for the dyno in 30-minutes after we wire it in and get it started, and I'll only need 30-minutes on the dyno.
#10
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,178
Total Cats: 1,681
- You have a GM IAT
- You have an LC-1
- You have a MAP hose run
- You have VICS wires laid
- You need the assembled MS
- You need a wiriing solution which I don't have the answer to (I vote for Boomslang pig-tail. If the guy who builds the computer wants to give me wiring directions, and he promises they will work, then I'll save you $80 and solder it into the harness and chop-off the factory connectors.
I bet you a case of Shiner that I'll have this car ready for the dyno in 30-minutes after we wire it in and get it started, and I'll only need 30-minutes on the dyno.
You could always go with a DIYBOB to make the boom slang part.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM