99 T28 Churbo 16psi Dyno Run
#1
Senior Member
Thread Starter
iTrader: (13)
Join Date: Jul 2007
Location: San Antonio, TX
Posts: 534
Total Cats: 8
99 T28 Churbo 16psi Dyno Run
I finally got my car tuned by Stephanie at BEGi after my engine rebuild a year and a half ago. I am running the T28 Churbo at 16psi. Engine got Supertech 84mm pistons, H Tuned rods, BE billet oil pump, LS9 Coils, Artech 3" downpipe and Enthuza 3" full exhaust. Here's my dyno plot.
Link to Youtube;
Link to Youtube;
#3
Senior Member
Thread Starter
iTrader: (13)
Join Date: Jul 2007
Location: San Antonio, TX
Posts: 534
Total Cats: 8
Thanks, yes it's BEGi's T28 Churbo. http://www.bellengineering.net/produ...roducts_id=404
Last edited by lsc224; 03-18-2015 at 11:44 PM.
#16
Senior Member
iTrader: (2)
Join Date: Mar 2014
Location: Meridian, Mississippi
Posts: 628
Total Cats: 44
What gear was the dyno run done in? Since you have the 6 speed 5th is your 1:1 gear so that is what I would have expected you to use on the dyno. It looked like 4th perhaps even 3rd was used... your spool up doesn't look that bad, but it would have looked considerably better in 5th.
Very impressive!
Keith
Very impressive!
Keith
#17
Senior Member
Thread Starter
iTrader: (13)
Join Date: Jul 2007
Location: San Antonio, TX
Posts: 534
Total Cats: 8
What gear was the dyno run done in? Since you have the 6 speed 5th is your 1:1 gear so that is what I would have expected you to use on the dyno. It looked like 4th perhaps even 3rd was used... your spool up doesn't look that bad, but it would have looked considerably better in 5th.
Very impressive!
Keith
Very impressive!
Keith
#18
Senior Member
Thread Starter
iTrader: (13)
Join Date: Jul 2007
Location: San Antonio, TX
Posts: 534
Total Cats: 8
So I have this GT2860RS turbo with 0.80 turbine sitting in my garage. Wondering is it worth swapping out with my Chinese 2871. I have a log manifold with a 3" Artech downpipe and a bottom end built 1.9L motor.
Any input would be appreciated. I've searched and I don't think anybody is running with this setup.
Any input would be appreciated. I've searched and I don't think anybody is running with this setup.