myfonti's first dyno results!
#1
myfonti's first dyno results!
i finally got my car dynoed! the before dyno was so unappealing that i almost cried(132rwhp@5psi)
right after that, i got a dp custom made at 2.5 in. and 3 in. test pipe with the rest of the piping to the magnaflow resonator and muffler at 3 in. as well...
the end dyno result was 152rwhp@5psi... not bad, right?
check my sheet! it was on a dynojet...
next is a clutch(break it in), then throw on my emb, 305cc injectors, jr afpr, 190lhp fp... i want 250rwhp! but ill settle for 230...
right after that, i got a dp custom made at 2.5 in. and 3 in. test pipe with the rest of the piping to the magnaflow resonator and muffler at 3 in. as well...
the end dyno result was 152rwhp@5psi... not bad, right?
check my sheet! it was on a dynojet...
next is a clutch(break it in), then throw on my emb, 305cc injectors, jr afpr, 190lhp fp... i want 250rwhp! but ill settle for 230...
#10
Once you get the WI in, I was able to run my base 12 degrees of timing, and only pull 2 degrees to eliminate all knock at 6psi, just to give you a better idea. But, I also rely on my WI a little bit too much. I am putting to gether a safeguards system for the WI, so that will give me some piece of mind. It will give you a little more power, but you have to be careful when messing with the ignition timing when incresing the cylinder pressures.
#14
great figures.
Its pretty amazing that you have gained approx 2orwhp by opening up the exhaust at the same PSI.
Surely thats like around a gain of 30+hp at the flywheel?
Anyway ...its convinced me to open up my exhaust another quarter inch.
I always thought it would make minimal difference.
Its pretty amazing that you have gained approx 2orwhp by opening up the exhaust at the same PSI.
Surely thats like around a gain of 30+hp at the flywheel?
Anyway ...its convinced me to open up my exhaust another quarter inch.
I always thought it would make minimal difference.
#16
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,204
Total Cats: 1,138
that's awesome. definetly means its a good downpipe. why am I so happy about this? because that downpipe is currently sitting out in the parking lot. IN MY MIATA! followed by a 2.5" cat, piping, and magnaflow muffler
hehe although I'm running a bipes pulling 10degrees, and 7.5psi. wonder what I'm making?
hehe although I'm running a bipes pulling 10degrees, and 7.5psi. wonder what I'm making?
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM