When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey guys I'm working slowly on getting everything set up to install. I'm new to any standalone stuff and I'm learning as I go. I currently have a ms labs ms3 mini for 01 to 05 miata. I'm looking at what else I need to do to the board before installing it in its case. I saw the electronic boost control pin that needs to be set up and idk where to hook it up to. Any help would be appreciated! I might just keep posting other stuff regarding this board here if more comes to light. Also anyone else want to add other questions or tips please do!
Looks like in the bottom left of your first picture, you can see CANL, CANH, and EBC.
The EBC pin is electronic boost control. Solder a .1" pin or wire in there.
Looks like in the bottom left of your first picture, you can see CANL, CANH, and EBC.
The EBC pin is electronic boost control. Solder a .1" pin or wire in there.
That's as far as I could figure out too haha. Do I just wire straight to solenoid and ground to the chassis or can I solder to a pin on the ecu connector so I can utilize the ground for the ecu
03-27-2020, 11:58 AM
Mslabs Mini ms3 setup question(s)
0
