engine bore and head gasket question
Thread Starter
Senior Member
iTrader: (1)
Joined: Oct 2008
Posts: 531
Total Cats: -19
From: Trailer County
engine bore and head gasket question
The engine block was bored from 83mm (stock) to 84mm.
Can I still use the stock Head Gasket that is set to 83mm?
I placed the stock HG and seems to be flush with the block and cylinder walls.
Can I still use the stock Head Gasket that is set to 83mm?
I placed the stock HG and seems to be flush with the block and cylinder walls.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
