Flex fuel sensor mounting bracket
09-22-2019, 05:07 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2017
Posts: 81
Total Cats: 12
Flex fuel sensor mounting bracket
Hey Guys,
planning to throw a flex fuel kit in the turbo Miata, I was trying to figure out how to mount the smaller continental sensor. It doesn’t have holes for mounting, I found a bracket on thing verse that might be a good solution! Printing it out and will install and provide pictures! Hope this will help out some people looking for some solutions!
https://www.thingiverse.com/thing:2965407
planning to throw a flex fuel kit in the turbo Miata, I was trying to figure out how to mount the smaller continental sensor. It doesn’t have holes for mounting, I found a bracket on thing verse that might be a good solution! Printing it out and will install and provide pictures! Hope this will help out some people looking for some solutions!
https://www.thingiverse.com/thing:2965407
Reply
0
0
09-22-2019, 05:53 PM
#2
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,177
Total Cats: 1,681
Just make sure you print it in ABS. PLA will not hold up in the engine bay. I have one printed and it fits great. There is also another cover part for it you can find on thingaverse to print also.
Reply
1
1
Thread
Thread Starter
Forum
Replies
Last Post
