Originally Posted by 18psi
(Post 920959)
Go check out thread called "project cheap" by Techsalvager.
If you like his herpey infested tub of diarheal sh*t of a car and setup and want FAIL and AIDS, go ahead and replicate it. It will cost just under 1800, and you will for sure have one of the worst cars on the forum. Good luck and have fun. |
Originally Posted by coltonr
(Post 920965)
everyone needs to understand i am only going to have the car for another 8 months before i move and am selling the car to a friend who is going to build the motor and put a bigger turbo on it. For now i only want some more power since at my altitude the car is bogging pretty bad.
|
Originally Posted by Leafy
(Post 920967)
Why spend any money on it at all? If you spend 1500 bucks on a turbo setup will you're buddy pay you 1500 bucks more than he would if you didn't do anything to the car other than change the oil twice, put gas in it, and wash it a couple times, between then and now?
|
Find JRSC, install and drive. Sell JRSC when you sell the car. Problem solved. Let friend deal with the turbo sh!t later.
|
i have dealt with cxracing in the past and their stuff can be squirley but has anyone seen this kit?? for 900
cxracing.com: 89-93 Mazda Miata MX5 T28 Turbo kit Bolt on + Downpipe |
Originally Posted by Doppelgänger
(Post 920981)
Find JRSC, install and drive. Sell JRSC when you sell the car. Problem solved. Let friend deal with the turbo sh!t later.
|
Ebay kit is trash, those manifolds will break shortly after installation. I highly doubt you'd even get the 8 months out of it.
|
Make a FS thread for a used Greddy kit for fuck's sake and stop retarding up this forum
Originally Posted by coltonr
(Post 920982)
i have dealt with cxracing in the past and their stuff can be squirley but has anyone seen this kit?? for 900
cxracing.com: 89-93 Mazda Miata MX5 T28 Turbo kit Bolt on + Downpipe |
Originally Posted by viperormiata
(Post 920987)
Make a FS thread for a used Greddy kit for fuck's sake and stop retarding up this forum
Yes. Buy this and install. |
I really do not think you realize everything that is involved in sourcing a kit. Can it be done for cheap? Yes but it would probably take you 8 months to find deals on decent parts so that it is not breaking left and right. There are lots of little things that need to be done. Do you even have a way to tune the fueling? You cannot run a turbo on the stock ECU unless you want to blow the motor up. You will also need to run lines for the turbo. You sound as if you have never turbo'd a car before which is fine, but you have no idea what is involved in the process. It will not be worth the $$ and headaches for 8 months of driving.
|
Originally Posted by Ryan_G
(Post 920989)
I really do not think you realize everything that is involved in sourcing a kit. Can it be done for cheap? Yes but it would probably take you 8 months to find deals on decent parts so that it is not breaking left and right. There are lots of little things that need to be done. Do you even have a way to tune the fueling? You cannot run a turbo on the stock ECU unless you want to blow the motor up. You will also need to run lines for the turbo. You sound as if you have never turbo'd a car before which is fine, but you have no idea what is involved in the process. It will not be worth the $$ and headaches for 8 months of driving.
|
You have NO idea. And I'm completely serious when I say this, not just flaming.
|
|
I have to agree this is a bad idea. If i was going dirt cheap i'd check out those t3 cast ebay manifolds for the 1.6, a china t3 of some kind (brain has/had one for a while and it was good, iirc), etc. At your altitude with a rising rate fpr and some static timing retard I don't see why you couldn't run 5-6psi (150whp) or so.
Be careful though, my stock greddy kit was running dangerously lean due to a failing fuel pump and I had no idea until i put a wbo2 on it. Oh and if you were keeping the car I would not recommend you go band-aids at all. Megasquirt is where its at. |
Originally Posted by coltonr
(Post 920965)
everyone needs to understand i am only going to have the car for another 8 months before i move and am selling the car to a friend who is going to build the motor and put a bigger turbo on it. For now i only want some more power since at my altitude the car is bogging pretty bad.
if he is a good friend i dont see a problem.. |
Originally Posted by Fireindc
(Post 921034)
I have to agree this is a bad idea. If i was going dirt cheap i'd check out those t3 cast ebay manifolds for the 1.6, a china t3 of some kind (brain has/had one for a while and it was good, iirc), etc. At your altitude with a rising rate fpr and some static timing retard I don't see why you couldn't run 5-6psi (150whp) or so.
Be careful though, my stock greddy kit was running dangerously lean due to a failing fuel pump and I had no idea until i put a wbo2 on it. Oh and if you were keeping the car I would not recommend you go band-aids at all. Megasquirt is where its at. This sounds like the best option for you so far. Cast ebay manifold and matching flange turbo. EDIT: Or if you can snag that setup in the classifieds if it looks decent. |
Originally Posted by Clos561
(Post 921067)
ask your friend to buy the turbo stuff he will put on the car after he buys it. Tell him you will "break in" all the turbo parts :giggle:
if he is a good friend i dont see a problem..
Originally Posted by slmhofy
(Post 921125)
+1
This sounds like the best option for you so far. Cast ebay manifold and matching flange turbo. EDIT: Or if you can snag that setup in the classifieds if it looks decent. This one?: https://www.miataturbo.net/miata-par...onetics-67793/ |
Shangai-s kit turbo held up pretty good. Lol (for those who know..)
|
I agree that it's a silly idea to start chopping up manifolds etc, but I'd like to know who of the people that say the MSM turbo is no good actually own one?
I have one on a '00 engine with 6sp and 3.6 and I think it suits the engine perfectly well. Agreed, it's a small turbo and goes out of breath over 10-12psi, but I like it. Oh, of course my car only weighs 1350lbs wet :D |
You just answered your own question.
|
All times are GMT -4. The time now is 07:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands